Assembling the massage chair is pretty straightforward and shouldn’t take long. Parts we need to assemble:   Armrests You can see the two lines for the armrest airbags taped to the chair.   Remove the tape from the lines so they’re sticking up:   Remove the screw at the back of the armrest frame:   Take the armrest, turn it sideways, and connect the air line:   Set the armrest on top of the frame, slide it into place, and put the screw back in:   Here’s what the armrest should look like now:   An inside view of the armrest and airbags:   Both armrests assembled:   Backrest Pad This is the pad that sits on top of the backrest. The plug you see in the picture is for heat. Only the sides (darker area) are heated.   Find the connector sticking out near the back of the seat, connect it to the backrest pad, and place the backrest pad over the backrest:   Secure the pad by zipping it to the backrest:   The backrest pad has a flap that attaches to the top of the chair:   Controller / Remote The controller sits in this holder that attaches to the side of the chair.   Line the holder up with the hole in the side of the chair:   Once the stud is sticking through, attach the nut on the other side:   Finished!   And remember, don’t use the chair if you’ve been drinking! 🙂   Current Lowest...